PlanetZ forums - scopeusers.com

Hi people!
I was been on holiday for a last few weeks. I will try all your tips and suggestions soon and I will inform you about results.
Thanks a lot and best regards!!!!

Regarding your question:

Think about what you have changed in your setup.
candidates have been named:
cables, preamps, interference from power chaords, new cards in PCI slots, different output levels,......
Thank you for answer!
I changed motherboard and CPU.
My new motherboard is ASUS M2N32SLI ...

Sorry for my bad english, but what means "dunno"?

Now I am sure thats normal to see bottom led on ST1632 mixer. OK...
One and only thing that I don't understand is:
WHY I SEE BOTTOM LED ONLY FOR A LAST FEW WEEKS????
NEVER BEFORE I SAW NOT BOTTOM LED ACTIVE!

THANKS!!!

ALL THE BEST!!!

are you plugging the guitar directly into the card without going through a preamp first? if so, the card can probably produce enough gain, but there will be noise, especially if you are using distortion.

the guitar's level is very low, about the level of a microphone(so a mic pre with a high ...

Thanks for reply!
All my cables are separated from power cords and shielded, but problem still exist.
What means "ground all only one times"?

Can I send my card to Creamware service???

Noise level is about -66db, but I have noise for last few weeks only. Never before I had not any noise on my Luna2.
If I use GuitarRig and load an preset with distortion, noise level is raised to very high level and any work isn't available.
What can I do to decrease noise level? I think that this ...

Hi!
I using Luna2 for a long times ago and I was very happy till few days ago.
I hear the loud noise on analog input at my Luna2. Even when I disconnect all cables from Luna, peak-meter on ST1632 software mixer shows input signal on strip where "Luna Analog Source" is connected. There is not insert ...

I think that its your mistake...
You should install ASPI using the "Run" command from start menu.

1. Click "Start" and select "Run".
2. Click "Browse" button and locate "install.bat" file (inside ASPI installation folder).
3. Now in the "Run" field you should see address of your "install.bat" file ...