VINCO

titodave · Post by **titodave** » Wed May 18, 2005 5:56 am

What parameters do you use on VINCO with a voice or a mix?
i´m using a focusrite comp but i want to use only the vinco, sell the focus and buy more DPS´s . i´m a sfp addict.
Thanks a lot and sorry another time for my english!

wayne · Post by **wayne** » Wed May 18, 2005 6:21 am

Alfonso's presets are a good start

titodave · Post by **titodave** » Wed May 18, 2005 12:40 pm

thanks a lot
very usefull!!!

firubbi · Post by **firubbi** » Fri Jun 03, 2005 1:41 am

Thanks alfonso,
its not possiable to insert Vinco. is there any reason behind this?
thanks

voidar · Post by **voidar** » Fri Jun 03, 2005 4:03 am

On 2005-06-03 02:41, firubbi wrote:
Thanks alfonso,
its not possiable to insert Vinco. is there any reason behind this?
thanks

Have you unlocked it, do you have it installed?

titodave · Post by **titodave** » Fri Jun 03, 2005 4:19 am

I can insert vinco in every channel but not the masterverb...

voidar · Post by **voidar** » Fri Jun 03, 2005 5:22 am

On 2005-06-03 05:19, titodave wrote:
I can insert vinco in every channel but not the masterverb...

Keep in mind that masterverg, or the verbs in general, only come in stereo, while vinco comes in both a mono and stereo version. Perhaps this is your problem.

firubbi · Post by **firubbi** » Sat Jun 04, 2005 6:15 am

On 2005-06-03 05:03, voidar wrote:
Have you unlocked it, do you have it installed?

Yes i'd install Mix n Master Pack where i got vinco. but not available at insert. do i have to do any change of setup?
thanks

Post by **garyb** » Sat Jun 04, 2005 9:51 am

sure it works as an insert. you must use the mono version in a mono channel and stereo in a stereo channel, of course....

valis · Post by **valis** » Sat Jun 04, 2005 10:02 am

Not available as insert means its not in the right place. You can navigate into your ScopeDevices directory and manually COPY the files (so that the old versions stay where they are as well) into the appropriate subfolders under the mono and stereo paths. Then the Vinco will show up as an insert.

Post by **hubird** » Sat Jun 04, 2005 2:19 pm

indeed, as you also can edit the SFP main menu bar to your convenience...not always obvious to everyone