P-plate problem

Conqueror's Reign · Post by **Conqueror's Reign** » Mon Jul 02, 2007 2:26 pm

Has anyone seen or had a problem box pop up saying module p-plate midi A is inappropriate for this hardware? Any ideas what could cause it?

Also is it possible with 2 or more cards to use all of the midi i/o?

Post by **garyb** » Mon Jul 02, 2007 3:13 pm

you might try reseating the i/o plate on the card.

yes, you should be able to use all i/o.

Conqueror's Reign · Post by **Conqueror's Reign** » Mon Jul 02, 2007 9:43 pm

Thanks Garyb will do!

A quick question about setups with more than one scope card.
If you have two different types of scope cards in the same pc is it neccersary to have the driver for each card installed or can both cards use the same driver?

husker · Post by **husker** » Mon Jul 02, 2007 9:45 pm

only one driver for all scope cards

Conqueror's Reign · Post by **Conqueror's Reign** » Mon Jul 02, 2007 10:32 pm

thanks husker, thats what i thought but it seems windows wants to install a driver creamware scope and a second driver creamware pulsar II are these the same driver different name or two different drivers? It seems if i use eithier or i get only that cards properties to show.

Post by **garyb** » Mon Jul 02, 2007 10:37 pm

no, windows will install the driver for each card. no big deal....

kylie · Post by **kylie** » Mon Jul 02, 2007 10:56 pm

the cards will show up with a different label since the PCI identifier is different, but imho the driver itself is the same. just let windows install the driver again.

-greetings, markus-

Post by **garyb** » Mon Jul 02, 2007 11:00 pm

yes, of course, you're right. but it doesn't look that way....

Conqueror's Reign · Post by **Conqueror's Reign** » Mon Jul 02, 2007 11:21 pm

Ok reseated the i/o plate but still get this problem box saying module p2 midi input not appropriate for your hardware. It seems to only pop up when i open the synth.pro in the examples folder. Also when playing synths notes hang inserted a midi monitor and only thing that shows is the note on and note off. Just installed a second scope card if that helps, thanks guys.

Post by **garyb** » Mon Jul 02, 2007 11:42 pm

oh, you just need to remove the midi module and put a new one in it's place. the computer is different now and the project needs to be rebuilt. make sure that both cards are recognized.

Conqueror's Reign · Post by **Conqueror's Reign** » Mon Jul 02, 2007 11:58 pm

growing pains