"No DSP Placement" error

[Kenf]

I have been sucessfully using my Pulsar2 and Electra cards for many years using the same projest in XTC mode. I had to re-install windows due to a windows config file error. I have re-installed SPF 4.5 and my XTC.pro no longer works. I get a capacity limit error "No DSP Placement" The project works fine in 'normal mode'. I have been through and connected each I/O module in turn. The project fails as soon as I connect anything to Z link dest. I have spent hours and hours trying to solve this problem and am feeling very disheartened...
I have a ASUSP4P800 mobo. The Pulsar is in slot 1 and Electra in slot 5 both share IRQ 21. I am using Cubase 3.1.
Any ideas? Regards
Kenf

[Kenf]

Hi,
I have tried the both cards on there own and they both work individually in XTC mode.. but not together when I use the Z link. I re-installed windows with the cards in place do you think it may be worth taking the cards out and re-installing windows. Then the cards one at a time???
Regards
Kenf

[garyb]

try running the Scope installer again(over the top of the old install).
perhaps this will fix whatever file has become corrupted....assuming that file corruption is the problem...

[Kenf]

Thanks garyb... I have tried that but will have another go.....
Regards
Kenf

[MD69]

Hi,

Rebuild your XTCproject.pro, some internals might have changed after your re install.

Cheers

[garyb]

yes, good call.

[Kenf]

Hi,
Thanks for your help... I have just realised I have been modifing XTC.pro not XTCproject.pro.... What an idiot I am... All works just dandy now... just like it used too.
Regards
Kenf

[garyb]

[Kenf]

Thanks again