these are the lines according to board priorities of my cset.ini
[hw]
numboards=2
intBlkSize=128
[board0] >>>>>> pulsar2 [irq19]...shares with ichr8 controler.
boardid=0
[board1] >>>>>> scope pro [irq20].....does not share and i want it to be master but not as first loaded
boardid=1
board1=host >> can i do this? board1=host? is this going make it?
i just want puslar2 to be loaded first in dsps but i want scope pro to be the host.
i know that it might seem a little confusing but is it possible?
cset.ini help
Re: cset.ini help
The host will be first in the dsp meter.
Re: cset.ini help
remove the cards,
start the pc one time,
shutdown,
put the pro card in your pc
start the system
shutdown
and then install the project card.
the ACPI of your bios and xp will load it as first one in the future.
dunno if this is what you ment.
start the pc one time,
shutdown,
put the pro card in your pc
start the system
shutdown
and then install the project card.
the ACPI of your bios and xp will load it as first one in the future.
dunno if this is what you ment.
Re: cset.ini help
this is the obvious, thanks but, what i am trying to do is to set the second loaded in dsps card as the host.
it is not possible in gigabyte dq6p965 to change the order and i have to make other changes inside for the boards to be fit vice versa in the pci slots.
so i am trying to avoid this.
if it is not possible then i would have to change the order of the boards in the mobo pci slots.
i mention that when pulsar2 is first in dsp loading thus host i notice more speed in loading and also some dsp overflow messages disappear.
with scope pro as first i have for example always a dsp overflow message when loading pro12, even in an empty project.
also gigabyte dq6965 is a mobo that sees the second(further to cpu) pci slot as first.
the option of setting the same irq in both pci slots does not exist and therefore i want to set as host the one that does not share with southbridge. if it was a usb i would had turned it off, ok, but now.......
it is not possible in gigabyte dq6p965 to change the order and i have to make other changes inside for the boards to be fit vice versa in the pci slots.
so i am trying to avoid this.
if it is not possible then i would have to change the order of the boards in the mobo pci slots.
i mention that when pulsar2 is first in dsp loading thus host i notice more speed in loading and also some dsp overflow messages disappear.
with scope pro as first i have for example always a dsp overflow message when loading pro12, even in an empty project.
also gigabyte dq6965 is a mobo that sees the second(further to cpu) pci slot as first.
the option of setting the same irq in both pci slots does not exist and therefore i want to set as host the one that does not share with southbridge. if it was a usb i would had turned it off, ok, but now.......