Scary error messages and crashes in XTC Mode only

[Rinse]

I'm using 2 Pulsar II boards succesfully for years now in SFP Mode. and had XTC mode running in the 3xx and 4xx era.

Now I was hoping to get XTC Running now it is supported in 5 but I get crashes and these error messages:

ScopeDriverloctl (1908900 returned error code -99

PepDisplayObject::GetHardwareInfo: invalid board-no 0


I'm using a ASUS P5Q-e and Cubase 5 as sequencer. and a NVIDIA 9500XT with latest drivers.

I tried With ACPI and without in a clean install but no succes....
I'm trying to fix this for days now but have no idea what's wrong..

Anyone some ideas?

[the19thbear]

The "scopedriver" error i something that happens when you use your daw with multiple cores. You have to set cubase to only use one core. I hope wc Will fix this soon

[pollux]

The "scopedriver" error i something that happens when you use your daw with multiple cores. You have to set cubase to only use one core. I hope wc Will fix this soon

I use XTC with Sonar and Reaper on my quad core, with all the cores on, and I never saw this error...

[the19thbear]

Its only a problem ón some motherboards. I have had 2 now with the same problem. Other users have reported this problem as well. But its great that its working for you!

[voidar]

This happens at times with me on my P4 with Hyper Threading enabled.

[the19thbear]

How dó you disable ht?

[voidar]

You have to do that in the BIOS, at start-up.

[the19thbear]

I'll try that. Thanks