Just wondering if anyone has been able to get a delta 1010 and pulsar to sync up yet?
What I have are two pulsar cards (Pulsar II and XTC) and I just want to run them as a big XTC card and use the Delta 1010 as my I/O card.
I am using logic 5.1.
This is how I have set it up
Pulsars Cards linked together as the Master.
Digital out of the pulsar into digital in on the Delta 1010.
Delta 1010 Slave.
In logic I have set the Pulsar to the ASIO driver.
In Logic I have set the Delta 1010 to the PC driver.
But when I run it they go out of sync.
Any ideas?
Thanks