Cannot read script file 'PepSurface'

pazpatu · Post by **pazpatu** » Tue May 14, 2002 9:11 am

Hello,
I can't install SFP 3.1 on my XP pro system.
I've updated the drivers of my pulsar 1 and srb2, I've downloaded the aspi 4.7 drivers and I'm admnistrator on the machine.
The first message is Cannot read script file 'PepSurface'. Then I must click on a thousand ones to get rid of messages...and then I must reboot in order for Pulsar to initialize itself one more time....
any idea welcome...
Papzatu

subhuman · Post by **subhuman** » Tue May 14, 2002 9:16 am

A few ideas/tips:

<li>Install to C:SFP - not another drive or directory - just as a possible solution
<li>Verify the integrity of your downloaded .ZIP file. Perhaps re-extract it.

I saw this message on the final release, but it seemed to be a corrupted ZIP file or so, installing RC1(beta) version doesn't have this problem, so it's either an installer issue on the final, or a corrupted zip/install you have there, not sure which yet.

pazpatu · Post by **pazpatu** » Tue May 14, 2002 9:19 am

I can't choose my install rep cos I can't read any message (other than PepSurface

Can I work a couple of days with the new drivers and 3.01 ?
Thanks in advance

subhuman · Post by **subhuman** » Tue May 14, 2002 9:21 am

If you have 3.01 installed still, it should work perfect with the new SFP drivers installed, just close SFP and open 3.01 and you can continue working...