No asio comutication with SFP

arish · Post by **arish** » Mon May 27, 2002 11:15 am

Just install SFP yesterday
and sense then cubase does not recognaize
the scope asio driver!
_ i open cubase a massage come - no asio commutication can be done-midi to audio connection !.
i did all the normal presiger:
hardware check-reinstalling the card.
reinstalling both cubase and SPF SoftWares.

i am running WIN98S
any Idea?

myself prefer the Pulsar v3.01 then SFP..

algorhythm · Post by **algorhythm** » Mon May 27, 2002 11:52 am

in options>audio>system in cubase, you have no scope driver? what is your clock source?

dbmac · Post by **dbmac** » Mon May 27, 2002 5:16 pm

This has happened to a number of people, including me. The common fix is to re-run the SFP 3.1 installation.

/dave the reinstaller

arish · Post by **arish** » Tue May 28, 2002 8:56 am

i unstall all the SFP program including all drivers manuly .
and now it´s working FINE with V3.01.
i don´t if i will ever put the SFP again
any way it´s too heavy and bugy!

t

arish · Post by **arish** » Tue May 28, 2002 9:03 am

When you look on other post here ,
you find that SFP has problem with asio scope driver with CUBASE !

CW should check this out !

I am tired spending hours trying to solve this problems.

SFP is not easy working with.

scopeman · Post by **scopeman** » Tue Jun 04, 2002 7:58 am

Hi arish,

I am working with SFP and Pulsar 3.01 and there was never any ASIO Problem.
I run sometimes the older Pojects under 3.01 and starting to create new Projects with SFP.
You can use 3.01 with the new SFP-Drivers,
so you can allways switch between these two versions without changing drivers.
I´m using VST and SFP on ME and ASIO is still working like it should.

subhuman · Post by **subhuman** » Tue Jun 04, 2002 8:46 am

SFP 3.1 was working wonderfully on my P4TE/1.8Ghz/XP system with Logic... I put on 3.1a last night (just installed it over top) and immediately noticed faster graphics on my larger/heavier (over 15dsps) DSP projects, so now I'm even happier. Recorded through ASIO without touching any settings after 3.1a ... so it is working in some cases very well.