ASIO on win11 Scope PCI V7 for Ableton

[dynamixii]

Hello all, I believe it used to work when you run scope and ableton in win8 compatibility mode but tried to select the asio driver for scope in ableton 10 and also 11 and I get a big fat no.


Any suggestions Team SFP ?

[dynamixii]

I had to add asio source and destination then it began working again....

[garyb]

whew!

[banex982]

Hello, how to set Scope for 8ch recording via Z-link 2496, I got v7 and installed all and on scope panel, I forgot how to connect devices so I cant record neather from Cubase 5, tried Ableton live, etc than I come to conclusion that I forgot how to set it, I am noob on this, last time I used hardware was on WinXP with Scope v3 and 12y ago, so if you can help me, screenshot of Scope Panel or if its easy just write me how to set it.

[Bud Weiser]

I´d use 2496 BUS outputs and connect to ASIO destination.
To connect, drag SCOPE´s virtual cables, source to destination channels.
Look into the SCOPE v5 manual in case you forgot HOW to drag cables in SCOPE environment.

When you want to record into Vdat,- forget it when using SCOPE 64Bit and Win10/11.

[nebelfuerst]

Dante (and me) wrote an article about scope and ableton. There's also a cubase article.

http://www.hitfoundry.com/issue_29/ab_mast.htm