Pulsar II and Mindprint Envoice

Dolphin · Post by **Dolphin** » Mon Jan 27, 2003 10:22 am

I just bought the Envoice with 24Bit/48Khz A/D-Module.

If I run Pulsar II in Slave-Mode, I can only receive 48Khz. With 44,1 (switchable) I do not get any sound.

If I run Pulsar II in Master-Mode, same happens.

Any ideas???

at0m · Post by **at0m** » Mon Jan 27, 2003 12:57 pm

Taken from SOS, http://www.sospubs.co.uk/sos/sep99/articles/mindp.htm

"Normally the A-D converter operates at one of the two standard base rates of 44.1 or 48kHz, as selected by a rear-panel slide switch."

Did you flip the switch?

Dolphin · Post by **Dolphin** » Thu Jan 30, 2003 3:58 am

Hi at0mic,

yeah, I did that - no result.

Meanwhile I posted my problem to the mindprint forum as it is obviously not a pulsar-problem. The guys there suppose that the reason is probably the switch which might be broken.

I just ordered the Behringer Ultramatch (need it anyway) which reads any sample-rate and delivers an output with 44,1kHz. I`ll see if that works.