<b>features:</b>
<ul>
<li>3 band compression</li>
<li>3 band softclip</li>
<li>phase coherent </li>
<li>build in look ahead detection</li>
<li>easy to use</li>
<li>bass delay</li>
</ul>
<b>known bugs:</b>
<ul>
<li>presetlist not working</li>
<li>dsp error @ 96 kHz (algorythm is too big for a single dsp)</li>
</ul>
...any suggestion is welcome
For some reason I get a DSP overload ("Big modules do not fit") message when trying to load this device. Strange error considering I have about 95% of my DSP load remaining. lol
On 2004-02-13 07:40, deejaysly wrote:
For some reason I get a DSP overload ("Big modules do not fit") message when trying to load this device. Strange error considering I have about 95% of my DSP load remaining. lol
Anyone else experience this?
the whole algorythm is calculated on a single dsp to avoid phase problems.
what board and what kind of software are you using?
On 2004-02-13 07:59, samplaire wrote:
I have no probs loading it - Mac Pulsar1/LunaII.
Andre, I've got a question on using it:
- what is the neutral freq adjust position? I've tried some and haven't found.
Yes, the gui is clear like a baby's chick
Thank you
_________________
Sir Sam Plaire Scopernicus
<font size=-1>[ This Message was edited by: samplaire on 2004-02-13 08:00 ]</font>
hi,
you get a neutral frequency when all 3 bands are set to the same level. (doubleclick) AND if there is no compression.
if you compress the signal, you have to adjust them manuelly...
Hi!
I'm very impressed. Sounds, as it is really phase coherent - I thought this is a difficult thing for multibands! Nice work.
I like it's surface very much, but what about a box which opens seperately, where you can adjust some other values: Frequency for each band etc.
The softclipping is a bit agressive for my taste. (When I use it for mastering, there is a very small point in the values which makes the right amount - and then a second later it overdrives the signal totally. Difficult to adjust.)I'd like to disable it. I find it very difficult to find values which don't distort too much.
But WOW!!!!! Very nice from you, to let us test the betas for free!!!!
On 2004-02-19 05:56, MCCYRANO wrote:
Hi!
I'm very impressed. Sounds, as it is really phase coherent - I thought this is a difficult thing for multibands! Nice work.
I like it's surface very much, but what about a box which opens seperately, where you can adjust some other values: Frequency for each band etc.
The softclipping is a bit agressive for my taste. (When I use it for mastering, there is a very small point in the values which makes the right amount - and then a second later it overdrives the signal totally. Difficult to adjust.)I'd like to disable it. I find it very difficult to find values which don't distort too much.
But WOW!!!!! Very nice from you, to let us test the betas for free!!!!
Sir 
