Cubase SX2 - XTC

woje · Post by **woje** » Sun Feb 29, 2004 8:39 am

when i try to open SX2, if first says: "Hardware version 11 detected, this hardware requires a software update. Please consult installation guide" and then: "cannot start software because board(s) or driver not properly installed, please check installation".

Yet XTC is working fine, what should i try, i have tried installing both programs in different orders, but no go. Anyone had this problem?

Basic Pitch · Post by **Basic Pitch** » Thu Mar 11, 2004 4:16 pm

Thats the message you get when SFP tries to run and it can not find your CW device, I would un-install your card and re-install the drivers properly..

If not atleast follow the manual and update the drivers so the card is selected as an audio device, see if that does the trick..

Cheers!