Pulsar2 hardware problem

meza · Post by **meza** » Sun Mar 28, 2004 9:43 am

After a big click and a freeze of scopefusion plateform (3.1c), when I launch the application I have this msg : "hardware cannot be setup properly:systeme error:timeout waiting for acknowledge from dsp0" then I click "ok" and a 2nd message does appear : "could not gain access CreamWare hardware!".
I tried reboots. I tried to reinstall software, but I can't, i've got the same messages... Hardware is still recognized by my system (win2k). 3/4 years without any problems... Anyone have an idea ? Is my pulsar board dead ? Thx

marcuspocus · Post by **marcuspocus** » Sun Mar 28, 2004 9:52 am

Update drivers with the one in the 3.1C directory.

You still have 3.1a driver loaded

meza · Post by **meza** » Sun Mar 28, 2004 9:56 am

Reinstalling drivers, that's the only thing I can do. Done. But I can't reinstall the software, I've always got that message, the same when I try to launch the app...

Post by **garyb** » Sun Mar 28, 2004 1:48 pm

hmmm.
that could be the sign of a bad card.contact support....

sorry.

on the bright side,cw can fix or replace it......

Me - Di · Post by **Me - Di** » Tue Mar 30, 2004 4:28 am

Try to reinstall the card itself.
Mabybee it moved or something.

And don't forget, shut your pc down first...

meza · Post by **meza** » Tue Mar 30, 2004 1:27 pm

I had a chat with someone from creamware france, it's the hardware... My card is getting back to germany... and in the same time SFP 4 is coming out :/ lucky !!

<font size=-1>[ This Message was edited by: meza on 2004-03-30 18:23 ]</font>