V-STACK AND XTC LATENCY PROBLEMS

sambo · Post by **sambo** » Fri May 21, 2004 5:33 am

Hi,

I have been using creamware products for about 2 years on a mac and recently moved the card into a pc to run with vstack. My problem is that when using vstack the latency on the XTC instruments is so bad that it is unusable, but there is no latency problem when i use the native VST instruments. i have frigged around with all of the settings and am running the card (pulsar 2 - SFP 4) at is highest possible samplerate but nothing makes any difference!!

Any Ideas???

sam

erminardi · Post by **erminardi** » Fri May 21, 2004 7:30 am

Try to open CTRL panel of ASIO when you are in V-Stack, then change on fly the latency of your CW Card (up or down) and then reset at your old latency.
In my system the latency delay disappear...
I hope that will resolve your problem

<font size=-1>[ This Message was edited by: erminardi on 2004-05-21 08:30 ]</font>

Kenf · Post by **Kenf** » Sat May 22, 2004 2:15 am

Hi
Have you checked out Gonzoft's tips....
http://www.planetz.com/forums/viewtopic ... forum=3&15
The ASIO panel does not appear to work in XTC mode, you must edit the Cset.ini file.
Regards
Kenf

marcuspocus · Post by **marcuspocus** » Sat May 22, 2004 4:32 am

Yeah right, cset.ini indeed

But also don't forget that V-Stack doesn't do any latency compensation...

Hey btw guys! Would you like a SFP for XTC, or kinda?

Have a try at the demo of this small host, you'll find the interface as some similarities with sfp

http://www.console.jp

I bought it last week, and having a blast with it

Zer · Post by **Zer** » Thu Jun 03, 2004 12:42 pm

well, actually I´m not into japnese language, but I`ve heard only good things about it.

marcuspocus · Post by **marcuspocus** » Fri Jun 04, 2004 1:28 am

There is a review of it on kvr-vst, and there is also a english section on thier site.

Zer · Post by **Zer** » Fri Jun 04, 2004 6:59 am

yep...but I wonder if I should give

http://www.xt-hq.com/

a try, too.