Transient Designer Problem. Please help me...

Drowningman · Post by **Drowningman** » Mon Jun 21, 2004 11:13 am

First of all, many many thanks to everyone for reading this

I'm getting this "Problem" message when I'm trying to load Transient Designer in my 3.1c SFP:

"Can't find DSP file SPL dynamic processor 2 - Please check installation"

The device loads fine, but only bypass works. I've tried to reinstall both the plugin and the whole SFP twice, but nothing happened (getting the same message). Any ideas? Maybe I'm missing just one file that someone can send me by e-mail? Or what the hell is happening?

Any suggestion is REALLY appreciated because I love TD so much... Same thing with both mono and stereo version.

Many many thanks in advance

[ This Message was edited by: Drowningman on 2004-06-21 13:49 ]

Drowningman · Post by **Drowningman** » Mon Jun 21, 2004 12:52 pm

Worked out by myself

The file that were missing were
SPLTDP2.DSP
SPLTDSP2.DSP
I simply had to copy from my old Scope directory to the 3.1c and evrything worked fine. Now I'd really love to discover what could have deleted those files, but I won't lose my head on it...

Now the problem is that even the .dll files from the VSTPlugins folder seems to have disappeared... Have I ghosts on my PC? If someone is so kind to send 'em by e-mail I'd really appreciate it for all the time I'm wasting with this incredibile thing (which is not so unusual 'cause I've seen that Basic Picth had the same problem with Vectron)

Thanks everybody in any case

[ This Message was edited by: Drowningman on 2004-06-21 18:55 ]

at0m · Post by **at0m** » Mon Jun 21, 2004 3:49 pm

I don't think they disappeared. My bet is they never got installed... [edit] After readin Basic Pitch post, have you tried Valis' tip?

Don't have these files, but you might fix it by copying 2 existing CW .dll files, from a mono and a stereo plugin, and rename them to the TD names...

Drowningman · Post by **Drowningman** » Mon Jun 21, 2004 4:43 pm

I think you're right at0m|c: I'm quite new to XTC mode so I've thought that .dll files should have already been there...

I've also tried with your trick of the renamed .dll: I can see the device in SX after refreshing plug-ins now, but it opens with no surface, so it doesn't work. I was guessing that the reason could be the .mdl extension of the SPL TD, so I've tried to rename it in a .dev one, but got no improvements at all after that. Still seeing no interface. I've also tried to open it using multiFX, but inside it I can't even see the TD (which is both in my "Devices" and in my "XTC Devices" folders).

Anyway I've read that there are people using it in XTC mode so if someone is so kind to give me a little bit of step by step to start me up it would be really great.

Many many thanks in advance

[ This Message was edited by: Drowningman on 2004-06-21 18:00 ]