PlanetZ forums - scopeusers.com

Hi All,

Snce I can not find anything on the forums, I'll have to post my problem here.

I just installed Pulsar II and Powersampler without enabling XTC mode.

Now everytime I start up the machine it says "Can't find DSP file deZipper - Please check installation". I have hooked up two synths and 1 sampler via Seq. midi source 1 into asio dest 64. It gives the error message three times, so I guess it has something to do with these three instruments.

Do any of you know what's going on?

I use Creamware i.c.w. Cubase SX.

Cheers,

Acid

<font size=-1>[ This Message was edited by: Acid Man on 2003-08-13 13:56 ]</font>

reinstall sfp.
If you first installed from a cd, copy cd content on disk before installing.

It's a file that didn't copy in the installation

Thanks for your answer.

Will try!

Acid

which mobo you have. do you have HT enabled in your bios?

the main thing i have found to be responsible for file not found errors is antivirus programs.no. 2 is a bad install.

I had the same problem today but it was solved by first uninstall Scope and then reinstall again.

If that file is already on your HD, just run a litte prog named "fixatrib.bat" (or smthng like that) an you're done!
It seems like the atribs of the files sometimes are messed up by the installer...
I think valis found that out and wrote that little prog to solve the problem.
If the installer didn't copy that file, I think it's possible to manually copy those files from your installer directory.
I had similar problems and solved them this way
ahh, just found it:

http://forums.planetz.com/viewtopic.php ... at#p239934

Cheers,
Jan

yes, this thread is very very old....