Page 1 of 1
Posted: Mon Oct 13, 2003 3:55 pm
by GonZoft
Prices are falling at CW and I am seriously thinking about buying the Mix & Master package for my 9 dsp system. However, since the release of Cubase SX 2.0, I mainly use effects in XTC mode. They get beautifully delay compensated all along the whole signal line now and one doesn't have to care about an additional SFP user interface with complicated additional routings from and into SX. My question is: do all these effects from the Mix & Master package work without problems in XTC mode? Talking about MasterVerb Pro, OptiMaster, PSY Q, Vinco, GraphEQ and Vocodizer.
Posted: Mon Oct 13, 2003 4:31 pm
by thorkell
I'm at least using optimaster, grapheq, and transient designer without problems in cubase sx XTC mode.
Posted: Mon Oct 13, 2003 4:32 pm
by thorkell
yes and Vinco as well
Posted: Tue Oct 14, 2003 3:31 am
by zezappa
After adding Mix&Master I just could get SX running (XTC) after deleting Vinco M and Grapheq (mono) *.dll's from Vst/Xtc folder, though with stereo versions no problem.
Before deleting those, my 9 DSP system had adverted "luna can not be used in xtc accelerator mode" and asio scope didn't load.
Strange, all the others xtc effects and synths are running fine.
Can you get Vinco M and grapheq M working in XTC, thorkell?
Posted: Thu Oct 23, 2003 4:17 pm
by darkstar
Hey can you please explain me HOW you use effects in xtc mode,I can't do that
I have Luna and Cubase SX,and I am searching this forum for answer...
My post
http://www.planetz.com/forums/viewtopic ... 22&forum=1
Thanks
Mirko
Posted: Sat Oct 25, 2003 7:49 am
by GonZoft
Posted: Sun Oct 26, 2003 3:34 pm
by thorkell
Well, Vinco both mono and stereo, and GraphEQ works flawlessly for me in XTC. Have you tried to update the plugin information in Cubase.
Posted: Sun Oct 26, 2003 9:22 pm
by zezappa
thanks thorkell, glad to know it.
I've tried everything I can imagine but I'll search once again...