Page 1 of 1
Posted: Tue Jan 06, 2004 7:34 am
by krisrocco
to start with it's not a major problem, just a little inconveniance. the prob as stated in subject is that i can't type values in value boxes in cw plugs working in xtc in cubase sx(sfp, too); the original value gets highlighted but nothing can be entered.
is this a common issue is there a cure???
i'm on PIII, 512ram, win xp,pulsar II, cubase sx
cheers, kris
Posted: Wed Jan 07, 2004 7:02 am
by wilbertenserink
hi,
I think this is a common issue with no cure. Maybe in SFP4. You can use sx2 automation for adjusting the xtc parameters or use midi cc's.
regards WIlbert
Posted: Wed Jan 07, 2004 3:03 pm
by psychoPat
hi krisrocco !
you said "SFP too" do you mean that you cannot type numerical value in value boxes? even under SFP? You have to use the standard numerical key i.e. not the numpad
wilbert, are you speaking about the issue on XTC parameters settings not saved with the cubase project (unless going through preset list
bye
Posted: Wed Jan 07, 2004 6:25 pm
by at0m
Posted: Wed Jan 07, 2004 7:08 pm
by alfonso
I'm not using xtc or 2.3 vst engine, but I've read of such a bug in cubase forums regarding some other plugs that didn't allow to enter numbers when in "always on top" mode. Check that too, it could be...