PlanetZ forums - scopeusers.com

Posted: **Fri Feb 06, 2004 2:53 pm**

Hello, all. I just connected a Syncplate to my
system. The Syncplate module shows up in the SFP routing window, but there is no option for "ext sync" in the samplerate settings. Aren't there supposed to be drivers for the syncplate?
Needless to say, my wordclock will not stabilize when trying to record from the optical inputs.
Thanks, Mike

Posted: **Fri Feb 06, 2004 4:58 pm**

I would be curious to hear this. I'm getting ready to use the sync plate for the first time in a few weeks from now.

Posted: **Fri Feb 06, 2004 6:30 pm**

Your samplerate settings window should look like this:

No need to install anything, it's part of the cards driver.
Are you sure you connected the cable correctly on both ends ?

Kim.

Posted: **Fri Feb 06, 2004 6:30 pm**

<font size=-1>[ This Message was edited by: kimgr on 2004-02-06 18:32 ]</font>

Posted: **Fri Feb 06, 2004 8:48 pm**

Kim : My samplerate source only says ; spdif,
Zlink 1 & 2, and ADAT A & B. No "ext adat" or
BNC.
Thanks, Mike