PlanetZ forums - scopeusers.com

when i try to open SX2, if first says: "Hardware version 11 detected, this hardware requires a software update. Please consult installation guide" and then: "cannot start software because board(s) or driver not properly installed, please check installation".

Yet XTC is working fine, what should i try, i have tried installing both programs in different orders, but no go. Anyone had this problem?

Thats the message you get when SFP tries to run and it can not find your CW device, I would un-install your card and re-install the drivers properly..

If not atleast follow the manual and update the drivers so the card is selected as an audio device, see if that does the trick..

Cheers!