PlanetZ forums - scopeusers.com

After a big click and a freeze of scopefusion plateform (3.1c), when I launch the application I have this msg : "hardware cannot be setup properly:systeme error:timeout waiting for acknowledge from dsp0" then I click "ok" and a 2nd message does appear : "could not gain access CreamWare hardware!".
I tried reboots. I tried to reinstall software, but I can't, i've got the same messages... Hardware is still recognized by my system (win2k). 3/4 years without any problems... Anyone have an idea ? Is my pulsar board dead ? Thx

Update drivers with the one in the 3.1C directory.

You still have 3.1a driver loaded

Reinstalling drivers, that's the only thing I can do. Done. But I can't reinstall the software, I've always got that message, the same when I try to launch the app...

hmmm.
that could be the sign of a bad card.contact support....

sorry.

on the bright side,cw can fix or replace it......

Try to reinstall the card itself.
Mabybee it moved or something.

And don't forget, shut your pc down first...

I had a chat with someone from creamware france, it's the hardware... My card is getting back to germany... and in the same time SFP 4 is coming out :/ lucky !!

<font size=-1>[ This Message was edited by: meza on 2004-03-30 18:23 ]</font>