Page 1 of 1
Posted: Tue Apr 20, 2004 4:12 am
by Laurenz
Hello people !
Great Forum !
I 'm a new Pulsarian with a problem
I run my Pulsar II in xtc mode and I want to use Gigastudio. In my xtc project I added gsif sources and linked to asio dest but I can't hear any sound, though the signal comes to Giga.
Could anyone send me an xtc project to work with Giga ?
Posted: Thu Apr 22, 2004 7:15 pm
by rodos1979
Hello!
What sequencer r u using? If you use SX or Nuendo then u have to add as many ASIO tracks into your project as your Giga channels.
Then you have to turn on Monitoring on all of them. Otherwise you will have no sound.
Hope that helps!
Posted: Fri Apr 23, 2004 3:25 am
by Laurenz
I use Cubase sx 2.
I tried to do as you suggest, but nothing.
The connections are:
GSif source to asio2 dest
I would like to attach a picture of the project to this post, but how can I do ??
Posted: Thu Apr 29, 2004 8:03 pm
by rodos1979
Have a look
here.
I did it tailored to the needs of another guy but you can change it and tailor it to your needs.
Hope that helps!
Posted: Tue May 11, 2004 4:11 am
by Laurenz
Euxaristo Rodos!
But unfortunally I stilla can't hear any sounds..
In particular,in Giga the keys light blue when you hit the vurtual keyboard , but no sound comes out form cubase.
I followed all your steps
Are you sure I must start Cubase before Giga ?
Thank you again
Posted: Tue May 11, 2004 5:34 am
by rodos1979
Hello Laurenz!
I am sorry to hear that it didnt work for you. I think you must be doing something wrong in SX. Have you tried to reset the I/O devices in the device menu in SX? Try this and it should work!
On 2004-05-11 05:11, Laurenz wrote:
Are you sure I must start Cubase before Giga ?
- 100%! If you start SX first, then the XTCProject containing the GSIF drivers gets loaded. So, when you launch Giga it finds the GSIF output drivers. If you do it the other way round, Giga will not find any GSIF drivers when initialized and will not output ANY sound!
Hope that helps!