big problem help plz!!!

deejaykurt · Post by **deejaykurt** » Tue Jul 27, 2004 1:26 pm

hi im new to this i just got my pulsar y-day.Ive got thr pulsar 2 card with scope 4 installed.Ive been trying for ages to figure out how i can open my pulsar plugins in my vst windown in nuendo can some1 plz help me on this?

paulrmartin · Post by **paulrmartin** » Tue Jul 27, 2004 2:12 pm

I got laughed at for asking this question when I started with my Pulsar2.

Since SFP devices are not VST, try this:

MIDI out from Nuendo to your Pulsar synth/
your Pulsar synth out to an audio input of Nuendo.

Think of your Pulsar devices as being hardware devices.

Does Nuendo have a plug-in enabler, like Logic does?

deejaykurt · Post by **deejaykurt** » Tue Jul 27, 2004 2:52 pm

I wanna use the card in xtc mode.
Ive followed all the instructions,the xtc plugins r installed into my vst folder in nuendo ,i have xtc mode enabled in the scope platform and i just cant get it working at all.The plugins dont appear in nuendo when i open it up.Has any1 ever experianced this problem and how did they sort it?

blazesboylan · Post by **blazesboylan** » Tue Jul 27, 2004 3:53 pm

Did you exit SFP?

Nuendo will pop up an error message when you first start it up, if SFP is running.

That's the only thing I can think of... Anyone else?

Incidentally, I assume you're looking to use the Scope effects in Nuendo?

Cheers,

Johann

Eon · Post by **Eon** » Tue Jul 27, 2004 4:05 pm

As I dont use XTC but tried it once, I will tell you this.

YOu have to find in Nuendo that Pulsars synths and effects and enable them. That's somewhere in prefereces, look for it and you will find it

_________________
Music, Me and Myself

<font size=-1>[ This Message was edited by: Eon on 2004-07-27 17:52 ]</font>