Posted: Sun Sep 26, 2004 5:45 am
just upgraded to SX3 on my 2nd pc. afterwards I discovered that I am no longer able to set ASIO Scope (Creamware pulsar-card) to "Slave to ADAT A".
Everytime I switch to that setting, SX automatically resets to "Master" after clicking Apply and OK.
this worked fine in SX2 and former versions (I do have 2 pc, connected via ADAT/lightpipe and 2 creamware cards/pulsar).
anyone with the same experience out there?
tom
btw.: I do use vsl extensively (Nuendo 2 and Cubase SX). this problem didn't affect vsl-functionality but anyway I think this could perhaps end up in crackling (having 2 cards set as master-clock ...)
Everytime I switch to that setting, SX automatically resets to "Master" after clicking Apply and OK.
this worked fine in SX2 and former versions (I do have 2 pc, connected via ADAT/lightpipe and 2 creamware cards/pulsar).
anyone with the same experience out there?
tom
btw.: I do use vsl extensively (Nuendo 2 and Cubase SX). this problem didn't affect vsl-functionality but anyway I think this could perhaps end up in crackling (having 2 cards set as master-clock ...)