Posted: Sat Jan 22, 2005 10:24 am
Hi all
(Cubase sx2, Win XP, 2 Pulsar II cards)
Bet you know the answer........
The cards are OK (12 dsps showing, bus for each card's in/out pair set up in SX, mixer channels showing)
BUT
2 strange symptoms:
A. When I route output to 'Stereo Out 2', nothing (but a little noise) appears from that physical output.
b. On the other hand the SX mixer shows the output of 'Stereo Out 2'appearing at mixer channel 'Stereo In 2' - even though I have nothing physically plugged onto the analogue input of the second card.
Looking at my xtcproject.pro, both cards' Ins and outs are there (MIDI too), but
-there's a merge module feeding asio2 dest from asio source
-there's a directplay module no connected to anything.
Any advice that will help me get the second card's outputs generating a real signal at the plugs (and not back into the mixer)?
Korgi
(Cubase sx2, Win XP, 2 Pulsar II cards)
Bet you know the answer........
The cards are OK (12 dsps showing, bus for each card's in/out pair set up in SX, mixer channels showing)
BUT
2 strange symptoms:
A. When I route output to 'Stereo Out 2', nothing (but a little noise) appears from that physical output.
b. On the other hand the SX mixer shows the output of 'Stereo Out 2'appearing at mixer channel 'Stereo In 2' - even though I have nothing physically plugged onto the analogue input of the second card.
Looking at my xtcproject.pro, both cards' Ins and outs are there (MIDI too), but
-there's a merge module feeding asio2 dest from asio source
-there's a directplay module no connected to anything.
Any advice that will help me get the second card's outputs generating a real signal at the plugs (and not back into the mixer)?
Korgi