Page 1 of 1
Posted: Sat Feb 12, 2005 9:48 pm
by Man-Machine
Ok, I have no problems using synths in XTC but I just tried using a mic with Pulsar inputs and I get no signal in the Cubase inputs. In my XTCProject I'm routing the Analog source to the ASIO dest. Isn't it right? Maybe there's something I need to do in Cubase to hear the input signals. It does show two active Scope input signals in Device Setup though. Ideas???
Posted: Sat Feb 12, 2005 9:57 pm
by garyb
using a mic pre?
scope mode is better for that type of work....
Posted: Sun Feb 13, 2005 8:33 pm
by Man-Machine
Yep, I got a mike gain going...
I just tried it on SPF and it works fine so it's gotta be something on my XTC project. Like I said, the synths work fine in XTC mode with my project but not the analogue source. Does anyone have a sample XTC project that have the synths and the analogue source working?
Thanks for all the help
Posted: Sun Feb 13, 2005 9:13 pm
by garyb
if you have the analog source routed to the asio dest 1 rl in the xtcproject.pro, it definitely should work.
Posted: Mon Feb 14, 2005 6:17 pm
by zezappa
monitoring activated...?
Posted: Mon Feb 14, 2005 7:18 pm
by Man-Machine
I'll check that again but it should be. Like I said, it works in SPF mode and my Cubase project is the same...
_________________
L8ter Oscill8ters!
<font size=-1>[ This Message was edited by: Man-Machine on 2005-02-14 19:19 ]</font>
Posted: Wed Feb 16, 2005 5:50 pm
by Man-Machine
I just re-did the merge module connections and now I get input in SX. Weird...
Another weird thing is that when I bypass the DirectMixerPlay module and go direct from the asio source to the analogue out I get no sound. I thought this module was only to help with latency and wasn't really necessary...
_________________
L8ter Oscill8ters!
<font size=-1>[ This Message was edited by: Man-Machine on 2005-02-16 17:51 ]</font>