Page 1 of 1
Posted: Thu Jun 09, 2005 3:14 pm
by Music Manic
.Just recorded loads of vinyl through Vdat and I have to say the sound is exceptional.I tried and A/B and couldn't tell which was vinyl.
Needed to bounce files in stereo which is a pain.
I also have TripleDat.Can this record in stereo and does it use same algorithms as Vdat?
Thanks
Posted: Fri Oct 07, 2005 8:49 am
by Wired
can you tell me how to record a wav file into vdat, i usually record it into soundforge, but i heard it sounds better in vdat
Posted: Fri Oct 07, 2005 10:37 am
by Music Manic
Well Vdat has its own format so record your sound source into 2 mono channels then open in soundforge.
You then have to sum both mono channels to stereo,which is the downside of Vdat but worth it.
Posted: Fri Oct 07, 2005 12:35 pm
by garyb
as far as i can tell, vdat and tDAT both use the same algos. they both sound exceptionally good.
Posted: Sat Dec 17, 2005 5:41 pm
by Wired
On 2005-10-07 11:37, Music Manic wrote:
Well Vdat has its own format so record your sound source into 2 mono channels then open in soundforge.
You then have to sum both mono channels to stereo,which is the downside of Vdat but worth it.
did that however when i open sf and load in the wav. from my vdat recordings, sf can't open them even when 24bit is specified