Hiya..I am trying to get Live 5 to run and it crashes as it loads when it trys to scan the Creamware synths, for example the bluesynth.dll. I am loading Live without having Scope open and it stops with the error
XTC plug not properly installed
I have no problems with XTC mode and Cubase SX 3.1 and all synths run perfectly fine.
Has anyone had the same problems and if so is there a way I can get Ableton to run correctly?
Please help I have a gig in 4 days!
peace
<font size=-1>[ This Message was edited by: flaminghoon on 2006-02-26 15:36 ]</font>
<font size=-1>[ This Message was edited by: flaminghoon on 2006-02-26 15:37 ]</font>
Ableton Live 5 and Scope 4.5
Nope - I made it work - it took a few hours, but in the end it worked.
There has been several threads concerning Creamware and Live recently, check them out for hints. Also theres a special thread about how to fine tune your XTC-installation, you might find some useful information here too.
Good hunting!
Thomas
There has been several threads concerning Creamware and Live recently, check them out for hints. Also theres a special thread about how to fine tune your XTC-installation, you might find some useful information here too.
Good hunting!
Thomas