Page 1 of 1
Posted: Mon Mar 13, 2006 1:20 am
by magforce68
I´m a complete newbie to Pulsar and Scope. I´ve finally managed to install my XTC-card. I want to run it in XTC mode in Cubase SX with my 1010LT card. Does anyone have a XTCProject.pro to share that would get me started? The manual doesn´t seem all that helpful...
Posted: Mon Mar 13, 2006 1:25 am
by garyb
if it's an xtc card with no i/o of it's own, i don't think you need a project.
if the card has i/o you must use those i/o in xtc mode. you won't be able to use the other card. in scope mode, it can be done using external patching, but why? the scope i/o is very high quality.
Posted: Mon Mar 13, 2006 1:37 am
by magforce68
Wow, that´s quick. So - my card has no I/O, and then I don´t need a project.pro? I just fire off from inside Cubase? Sound almost to good to be true...
))
Posted: Mon Mar 13, 2006 1:48 am
by garyb
i think so..
first you need to install the driver, then the software.