Page 1 of 1
Graphical problem whith PEQ4 in XTC Mode - please help
Posted: Wed Mar 28, 2007 7:39 am
by tonschieber
Do anybody use the PEQ4 in XTC-Mode with Nuendo or Cubase and did an automation of this Plug-In so far?
Have somebody graphical problems with the PEQ4 in XTC-Mode?
Please give me a message.
Thank You for answering.
Best regards
Posted: Wed Mar 28, 2007 2:43 pm
by tonschieber
Here I will discribe my problem:
The PEQ4 stereo was placed in the insert of my Nuendo mixer.
When I set a bell-(peak)-filter to 20 kHz with a gain of +12 dB
and make an automation for a filter-sweep down to 20 Hz
the filtercurve still rests in same position (20 kHz)!
If I moove the mouse over the PEQ4 surface during the automation runs,
the parameter knob were mooving stagnant (not fluently).
The curve is still frozen.
After a long automation Nuendo crashes!
Have anybody remarked same problems?
Maybe somebody can help me out.
Posted: Mon Apr 02, 2007 3:56 pm
by tonschieber
This thread is closed.
For news use the link below:
http://www.planetz.com/phpBB2/viewtopic.php?t=21902