sequence-able 1->4 switch module?

justin3am · Post by **justin3am** » Sat Sep 08, 2007 1:51 pm

I'm looking for a switch module that has 1 in and 4 to 8 outs whose routing can be controlled from a sequence module, a trigger or any other modulation source.

Right now I'm using a sequencer in Numerology and sending the data as a CC to the normal 1->4 switch but it would be much easier if there was a module with a control input for the output selector.

Thanks in advance for any info you can give me.

3am

at0m · Post by **at0m** » Sat Sep 08, 2007 2:42 pm

First off, this post should be in Device/Module Wishlist. The Devices section is for posting, euh, devices.

Sequenceable? Check out Flexor's Granular Sequencer! See here and here.

I remember this MIDI controllable output selector, but I forgot its name and since the Scope machine here is waiting on a replacement for its fried motherboard, I can't check it for the name of that device... Anyone else? I think it was dark blue/purple, and had like 8 outputs...

Greetings,

at0m.

justin3am · Post by **justin3am** » Sat Sep 08, 2007 3:25 pm

oops! I didn't see that section before. As you can see, I'm new here. Thanks for the info just the same, I hope to e aquiring Flexor III in the next week or so so I'll have a look at that.