Page 1 of 1
Midi Through
Posted: Mon Jan 14, 2008 6:49 am
by firubbi
is there any way to use Midi Through as 2nd Midi Out?
thanks a lot.
Posted: Mon Jan 14, 2008 7:27 am
by Shroomz~>
No it's not possible. There's no access to the thru port in the routing window, so the midi input signal can't be disconnected etc.
What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.
Posted: Mon Jan 14, 2008 7:43 am
by pollux
<~Shroomz~> wrote:No it's not possible. There's no access to the thru port in the routing window, so the midi input signal can't be disconnected etc.
What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.
HLD loopback device does the trick quite nicely. I used it to redirect my controller keyboard input straight to a scope synth without having to load a sequencer
Posted: Mon Jan 14, 2008 10:43 am
by nightscope
<Shroomz> wrote:What we need is a universal usb midi module so that we can access usb midi devices from within the sfp routing window.
Yes. Just a bit. I could do with one of them!!
ns
Posted: Mon Jan 14, 2008 1:47 pm
by Neutron
careful with HLD and sequencers. the problem might be better now but back in the day of p3s you could hear the HLD causing wavering if you make a sequence of identical hihats on 32nd, and play it really fast so it becomes a tone.
then i uninstalled it and the tone became steady.
when using the sequencer to play scope or outboard devices, the effect was a very hard to pinpoint strangeness about the timing.