PlanetZ forums - scopeusers.com

Hi, silly question perhaps but despite searching I can't find the answer. Does anyone know if XTC mode will work if the VST host is set to use a different asio driver from the scope one?

And if the answer is no, any workarounds?

Thanks

Hi,

Not a silly question at all. I remember a topic about it but I can't find it anymore.
My personal opinion would be "No you can't" though...

So... After some search, it appears that some workaround exists:

http://forums.planetz.com/viewtopic.php ... thout+ASIO

Hope that helps...

Sorry, I dunno if the previous link is working.

Try this one : http://forums.planetz.com/viewtopic.php?f=32&t=26264

PS: best to read it to the end!

Hmmm! And another one that could be of interest:

http://forums.planetz.com/viewtopic.php?f=32&t=24764

as you can see, the forum has some answers, even if it so often looks grimy

Hi,

Yes it works !!

Look in here http://forums.planetz.com/viewtopic.php?f=32&t=23331

P.L.U.R

iSiStOy, Thanks for the links, this one http://forums.planetz.com/viewtopic.php?f=32&t=26264
had the answer, the 'jumper trick' is all I had to do, I can't believe it was that easy. Thank you for taking the time to find the right thread.

And Microraver, thanks for the other link.

Now, I have the XTC plugs loaded in chainer using my soundscape asio driver, and can use the plugs as effects sends from the soundscaper mixer in my mixpander/red 32 set up. This is fantastic!

No pbs.
There are lots of good posts about XTC: you could also check infos regarding how to use third-party plugins with XTC if you haven't done already.