B2003 AND NOVATION W/ SPACEF CC2 x 2 ( x2 ) for YaYaJohn
Posted: Sat May 16, 2009 10:42 am
The B2003 will remember the drawbar settings only in SFP 4.5.
You will need to re assign the Rotary speed manually on start up every time.
Fortunately the developers at SC read these forums and have corrected this in SFP 5.0 which will be released soon..
, along w/ many suggestions in regards to 3D/transparent modules in the project window, etc.
We should definately Skype when you start this. Here's the devices from SpaceF.
http://www.spacef-devices.com/dacore/in ... info&id=59
I had no room for the B2003 preset. I will add it once you respond to this weak attempt to explain the use of these beasts.
You must type in the values of each CC in the SpaceF devices.
You will need to re assign the Rotary speed manually on start up every time.
Fortunately the developers at SC read these forums and have corrected this in SFP 5.0 which will be released soon..
, along w/ many suggestions in regards to 3D/transparent modules in the project window, etc.We should definately Skype when you start this. Here's the devices from SpaceF.
http://www.spacef-devices.com/dacore/in ... info&id=59
I had no room for the B2003 preset. I will add it once you respond to this weak attempt to explain the use of these beasts.
You must type in the values of each CC in the SpaceF devices.
