PlanetZ forums - scopeusers.com

Posted: **Wed May 04, 2011 2:23 pm**

Hi,

I searched the forum and found that some people sucessfully managed to run Cubase SX3 on Windows7.

I use Windows 7 32bit, Scope 5.1 (yeah, I did the upgrade) and Cubase SX3 (officially buyed version with USB dongle, no H20).
I sucessfully installed both.

But Cubase crashes at start an says that some drivers are not properly installed.
What do I wrong?

Thomas

Posted: **Wed May 04, 2011 8:44 pm**

run as admin(Scope too)?

Posted: **Thu May 05, 2011 1:25 am**

Yes. I've tried all combinations. Admin (yes/no) XPKomp (yes/no)

Scope seems to work. I played something on youtube in Internetexplorer (via Wave drives).
When Cubase starts its says drivers are not properly installed programm will closes.
Once (dont remember the combination) scope crashes (communication error with board).

PlanetZ forums - scopeusers.com

Can't get Cubase SX3 to start on Windows 7

Can't get Cubase SX3 to start on Windows 7

Re: Can't get Cubase SX3 to start on Windows 7

Re: Can't get Cubase SX3 to start on Windows 7