Page 1 of 1
scope xtc mode fl studio export file no sound
Posted: Fri Aug 15, 2014 7:28 am
by heiwa_boken
hello
i have the scope xtc mode in fl studio when I export there is no sound in the file
but when i play the seqencer (fl studio) there is the sound.????????????
Re: scope xtc mode fl studio export file no sound
Posted: Fri Aug 15, 2014 4:22 pm
by ShogunSpy
Hi
Scope synths and effects will not work like this. You Have to imagine that Scope synths and effects are like real hardware..that's why they sound so good
I Have not used FL so sorry can't help you anymore. If you use SFP mode in scope you can record into VDAT.
Re: scope xtc mode fl studio export file no sound
Posted: Fri Aug 15, 2014 11:52 pm
by dante
in SPF mode, you can 'mix down' your track by routing the final stereo output of the Scope project to ASIO outputs that your host sequencer can use as input to a stereo mixdown track.
Re: scope xtc mode fl studio export file no sound
Posted: Wed Aug 20, 2014 2:34 pm
by YISH313z
dante wrote:in SPF mode, you can 'mix down' your track by routing the final stereo output of the Scope project to ASIO outputs that your host sequencer can use as input to a stereo mix-down track.
+1
Also if you are using XTC i Believe you can setup your XTC project before hand to output to ASIO but be careful not to have the mixer channel in FLS, that's receiving the asio input, sending to the master in the FLStudio mixer.