PlanetZ forums - scopeusers.com

when It's released I can help on this subject

I mean for all those wanting help with routing/combining programs within it with external/internal effects etc.

My first question about SFP for you Paul.
I’ve just installed the SFP for the first time a couple of hours ago and the bottom bar Icon (the little one) of Scope, do not show itself when you switch the program off like it would show itself when you closed the Pulsar program. This, of course, closes any possible connection with the audio-card itself, so no connection it’s possible without having Pulsar open. Is it a problem with my installation or is it supposed to be that way? So to do anything, using Winamp, etc., I’m forced to open Pulsar.
Thanks for you help.

Just so this..., so yes, unfortunately something is going on:

First, coudnt close the computer, it would say:

SFP caused an invalid page fault in
module <unknown> at 0000:00000038.
Registers:
EAX=00790e1d CS=018f EIP=00000038 EFLGS=00010216
EBX=00790ecc SS=0197 ESP=0066fb60 EBP=0066fbec
ECX=00790ec8 DS=0197 ESI=00790ec8 FS=2b2f
EDX=00790e41 ES=0197 EDI=00790ec8 GS=0000
Bytes at CS:EIP:
9a 00 9e 11 65 04 70 00 07 00 52 cb 4d f8 00 f0
Stack dump:
00000000 00790ec4 00790ec8 00790ecc 00000000 00000000 00000000 0041da98 00417713 00000000 00000000 00000001 0041da98 00410000 00790ec0 0066fda4

An then, a second screen would say:

Error Starting Program
The APITRAP.DLL file cannot start.
Check the file to determine the problem

I have reinstall the program, uninstall it, reload the new driver, etc. Started the procces again, but nothing... What can I do please?

I realise this is not the place to do it, sorry. It was a different question at the beginning, but it has become a problem and it should be in the problem solving Forum...

((i followed nestor's advise.))

<font size=-1>[ This Message was edited by: at0mic on 2002-08-01 09:48 ]</font>