PlanetZ forums - scopeusers.com

I've got a little problem with the new SFP's mixer (1632). It will be hard to explain in english (I'm French....and there's no french support). When I want to set the level meter in OUTPUT mode (after the Insert effect section) I can't see anything ! I must connect each channel out (32) to another module to see the level in Output mode ! I hope you will understand... I'm a LUNA user and if I want to connect all the channel output, I must load a device who can connect them (I use the AUXRACK), and I lose DSP just for it !
With the 3.01 version, the level mixer can show me the Level input and output without connect each channel to another module!.......
IS IT A BUG OR AM I MADE?
Another question for the XTC mode : Can i make a project files for the XTC mode (with MIDI connection and others modules)....Because without it, the XTC mode is a big big big shit !
I hope you will answere me quickly because I have to make a Master for the end of the week and It's hard without the level Meter !
PAO

It's not a bug, you might misunderstand the Output knob. It's to monitor the outputs of each channel. read STM1632.pdf p.6 and all will be more clear to you.

Funny At0mic, cuz on Creamware forum, Ingo responded with 'known bug'. And said they will fix it. Too bad for the bug, but at least, they will fix it in next patch.