PlanetZ forums - scopeusers.com

Posted: **Fri Aug 23, 2002 4:30 am**

Hi,

I just updated to SX 1.03 and have to announce, that the display bug with the levelmeter in the master section is still there when using Asio 32-Float. During playback levels always indicate +60 db, no plugins are used.

I don't know if it is a bug in the Creamware 32-float drivers or in Cubase SX???

Fortunately the audio recordings/exports don't show any errors, so it should be only a display issue.

There were no sensible replies in the cubase forum.
Any ideas here in Pulsar community?

Thanks in advance,
EC-HQ

Posted: **Fri Aug 23, 2002 10:59 am**

I would think it's a Cubase bug since it works okay in Logic??

Posted: **Fri Aug 23, 2002 11:22 am**

Confirmed. The SX VST Outputs meters "red line" on any channel that a VST instrument is routed to. Only with Asio Scope 32 flt drivers.

/dave

Posted: **Mon Sep 02, 2002 1:33 am**

Does this error still occur together with SFP 3.1c and Cubase SX 1.03?

<font size=-1>[ This Message was edited by: Eurocide on 2002-09-02 02:33 ]</font>

Posted: **Mon Sep 02, 2002 9:34 am**

Yes, no change.
/dave

Posted: **Mon Sep 16, 2002 8:02 am**

Confirmed too.
To properly work with Cubase SX I'm must using ASIO 2 32bit/64 source module in any SFP project.
I don't know WHY

PlanetZ forums - scopeusers.com

Pulsar Asio 32-Float and Cubase SX Master-Levelmeters