Page 1 of 1
Posted: Mon Jan 27, 2003 10:22 am
by Dolphin
I just bought the Envoice with 24Bit/48Khz A/D-Module.
If I run Pulsar II in Slave-Mode, I can only receive 48Khz. With 44,1 (switchable) I do not get any sound.
If I run Pulsar II in Master-Mode, same happens.
Any ideas???
Posted: Mon Jan 27, 2003 12:57 pm
by at0m
Taken from SOS,
http://www.sospubs.co.uk/sos/sep99/articles/mindp.htm
"Normally the A-D converter operates at one of the two standard base rates of 44.1 or 48kHz, as selected by a rear-panel slide switch."
Did you flip the switch?
Posted: Thu Jan 30, 2003 3:58 am
by Dolphin
Hi at0mic,
yeah, I did that - no result.
Meanwhile I posted my problem to the mindprint forum as it is obviously not a pulsar-problem. The guys there suppose that the reason is probably the switch which might be broken.
I just ordered the Behringer Ultramatch (need it anyway) which reads any sample-rate and delivers an output with 44,1kHz. I`ll see if that works.