Posted: Thu Mar 13, 2003 3:36 pm
Hi all,
Today I finally got me a VC-8 breakout box and started to install it.
I followed the Pulsar manual and connected the ASIO Source module to the ADAT A Dest module. When I wanted to start playing some VST instruments (Cubase SX) I only got signal on the left channel. When I look into the VST output box I am able to select the 4 busses and I also see the VU meter's left/right output, however I see that in the pull down menu I can only select adat a 1, adat a 3, adat a 5, etc.
Does this have to do with the VC-8 or is there just a mono signal coming out of the Pulsar card?
Any suggestions?
Cheers,
Acid
Today I finally got me a VC-8 breakout box and started to install it.
I followed the Pulsar manual and connected the ASIO Source module to the ADAT A Dest module. When I wanted to start playing some VST instruments (Cubase SX) I only got signal on the left channel. When I look into the VST output box I am able to select the 4 busses and I also see the VU meter's left/right output, however I see that in the pull down menu I can only select adat a 1, adat a 3, adat a 5, etc.
Does this have to do with the VC-8 or is there just a mono signal coming out of the Pulsar card?
Any suggestions?
Cheers,
Acid