Posted: Sun Apr 20, 2003 10:25 am
I edited my xtcproject file because I'd like to start using xtc mode. The project loads 32 bit asio drivers and everything seems to work, though in Cubase I can only choose 16 or 24 bit drivers?
I'm confused???
Second thing is, in sfp mode I load the control room so I can switch my monitoring between my Pulsar 1 and my pulsar 2. How can I set up such a thing for xtc mode, since loading the control panel device obviously doesn't work?
<font size=-1>[ This Message was edited by: MarcelG on 2003-04-21 18:11 ]</font>
I'm confused???
Second thing is, in sfp mode I load the control room so I can switch my monitoring between my Pulsar 1 and my pulsar 2. How can I set up such a thing for xtc mode, since loading the control panel device obviously doesn't work?
<font size=-1>[ This Message was edited by: MarcelG on 2003-04-21 18:11 ]</font>