Page 1 of 1
Posted: Thu Jun 19, 2003 12:37 pm
by enb141
I have a Luna II when I try to use the XTC this message appears to me "XTC can't be loaded in acceleration mode", why appears that message to me?
Posted: Thu Jun 19, 2003 1:11 pm
by at0m
Posted: Thu Jun 19, 2003 1:28 pm
by enb141
That is for Luna II too?
can I fix it adding a SCOPE SRB?
Posted: Thu Jun 19, 2003 2:06 pm
by siberiansun
nah.. before you open your wallet, try a complete reinstall of SFP.(3.1c)
i ran my luna II in XTC mode without any "accellerator" problems for 6 months before adding a pulsar II.
just remember to backup projects etc before reinstall.
good luck.
Posted: Thu Jun 19, 2003 3:14 pm
by enb141
It happened to me twice (I formated my computer and installed again) and I still have the same problem,
The question about SCOPE SRB was because that soundcard has a lot of DSP so I wish to know if that card has that "chip"?