PlanetZ forums - scopeusers.com

Hello, Sorry for "cannot be used in XTC accelarator mode" problem again.

I have PulsarXTC + Powersampler + Pulsar1, total 13 DSP.
I installed them in PC with this order (PulsarXTC is next to AGP slot).
In DSP meter of SFP3.1c, it shows as follows:

1/1 1/2 1/3 1/4 1/5 1/6 2/1 2/2 2/3 3/1 3/2 3/3 3/4

but,even in this situation, "Powersampler cannot be used in XTC accelarator mode" dialog still appears when starting CubaseSX 1.05.
although,It seems that PulsarXTC is the 1st and the master card of them.

I also tried to configure my cset.ini, adding
[board0] boardid=0 , [board1] boardid=1 , [board2] boardid=2 (just the sequence), in vain.

sorry for my poor English.I am one of the Pulsar User in Japan, where NO distributer exists.


AthlonXP 2400+ , Leadtek K7NCR18G Pro, 1GB RAM, CubaseSX 1.05

Again, Sorry for my annoying posting.
After All, I solved this problem by upgrading Cubase SX to 1.06.
I still don't know what caused the original problem,but I can concentrate on making music from now on.

I got second-handed PulsarXTC in Tokyo at the price of approximately $230, just after CW filed an application for protection.
Too Much Great Great Synthesizers for that price.

thanks.